
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
HUBBARDTONFORGE.COM
-, -
154 RT. 30 SOUTH
•
CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge
®
. All rights reserved.
28841 B
Installation Instructions
To Install the Canopy (Figures 1 & 2)
(Continued)
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
8. Raise canopy (D) and xture close to ceiling. Align holes
in canopy (D) with holes in crossbar (A) and secure with (2)
#8 screws (E).
9. If xture needs to be lowered to achieve desired height,
loosen gripper nut and push up on canopy gripper (F) and
gently pull down on supply/support cable (G).
Note: Excessive movement of cable through the gripper could
cause cable to fray slightly. Usage of the cable gripper is not
recommended to frequently adjust the xture up and down in
height.
To Install Metal Shade & Glass (Figure 3)
Component Parts
H Socket
I Metal Shade
J Glass
K Washer
L Retaining Ring
M Retaining Ring Tool
1. Remove retaining ring (L) from socket (H) and retain for later
use. Retaining Ring is shipped installed.
2. Install bulb (not included). Be careful not to touch bulb with
bare hands; oil from the hands will dramatically reduce bulb
life.
3. Place metal shade (I) over glass (J) and then place glass (J)
over socket (H).
4. Set washer (K) over socket.
5. Thread retaining ring (L) onto socket (H) and tighten using
retaining ring tool (M) until snug against glass (J). Do not
over-tighten.
6. Restore electricity at the main breaker.
A344
Staccato Pendant Vintage Platinum: 161090
Page 2 of 2
J
K
L
(Figure 3)
M
H
I
Kommentare zu diesen Handbüchern